Overcome strikes Car

Overcome strikes Car

There was Not every driver is a mechanic/ can repair their own car. may be we need cheap auto insurance , The problem is : Strikes car certainly make us very upset. Moreover, if the car broke down at times when things were rough or we are in a hurry. Indeed, the car broke down was not need to happen if you diligently take care of your car engine well. But sometimes fate is definitely not looking up to you so that the car broke down in the middle of the street into something that was inevitable.
For those of you who know well about the possible engine problems stalled car will not make you be totally freaked out. But what about those of you who only have very little knowledge about it? Take it easy because this article will give you some tips BlogOtomotif Practical Car Strikes Deal that you can do it yourself and not too demanding if you understand well the engine or just know a little.
Basically, the engine can run as there are 3 components of the motion, the power supplier, distributor ignition and fuel supply. 
Therefore, before calling a mechanic to repair, should Kila can check these components. Here are the steps you need to do when your car broke down:
1. Push the car to the side of the road if your car suddenly broke down right in the middle of the road.
2. Check the power supplies
The components consist of battery power supplies and converters of high voltage coil. Battery provides power when the machine is first turned on. Voltage 12 volt battery, the coil will be increased up to tens of thousands of volts. This voltage is supplied by a distributor and platinum or CDI (capacitor discharge ignition) to the spark plug for ignition. The engine will be hard to live if there is a problem in the battery and coil. The indication is currently difficult distarter engine lift. timing slow wheel rotation. Koil is rarely problematic, if any, are usually the problem lies in the cable, ie not connected or broken. While the battery. problems that often arise less stun or short term. As the solution is removed and the battery charged. Problems can arise because the battery connection at poles (head) battery loose or corrosion. To overcome this, tighten the screws on the battery poles, and clean the dirt.
3. Check the Ignition
When the component power supplies is no problem, the next step is to check the ignition components. This component consists of a distributor, platinum or CDI, and spark plugs. All plugs are checked and sanitized. Machines can limp because one spark could be dirty or dead. Replace the spark plug wires and make sure it is installed properly on the head distributor. Distributor opened and inspected platinum, then see whether the surface dirty or worn. Clean with sandpaper and reinstall. Make sure all the cables that connect the distributor to the condenser, spark plugs and coils connected properly.
4. Check the Fuel Supplier
Note the fuel component supplier. That carburetor (for cars still use carburetors) and a gas station. Of the gasoline tank, fuel is pumped into the carburetor. A mixture of gasoline and air channeled into the ignition to move the engine or piston.
Problems that occur are mostly gasoline carburetor or fuel shortages. When this happens, the engine will not turn. Open the carburetor air filter, if it floods, leave it open for a while and start the engine without stepping on the gas pedal or stomp deeply. Once the engine starts, release the gas stamping. If the fuel supply is less, may be due to dirty carburetor. When that happens, the carburetor needs to be cleaned.
In addition to the carburetor, fuel pump that is not perfect or damaged can also cause the car broke down. Gas station can also wear on the valve, so it is not working properly. To detect it: Remove the fuel hose and then input end into the bottle. Then the car starter. If the fuel is still flowing, the fuel is still functioning well, and vice versa.
5. Check the starter switcher wear
Devices that do look trivial and often not recognized by the user or owner of the car. In fact, the possibility of damage to the device is very large. Understandably, switcher most often used when the user is in the car began to turn on or off the vehicle engine.
In general, damage occurs in a loose cable, metal contactor plus minus for connecting an electric current is worn so it is not connected. Replace immediately if you suspect problems.
But when you experience it in the way that lonely and away from the crowds, the emergency measures are plus and minus cables connecting starter. How to use a pin or a small sharp wire, and connect the two wires with a pin or small wire is.
Some of the tips above are just the first step the handling of the car broke down. If you've checked all the parts but the result is still nil, there is no other way but to call a crane and take your car to the nearest garage. Hope it helps. or other way is we need cheap car insurance .

Bagikan ke :

Facebook Google+ Twitter
Posted by Rewa lee, Published at 8:32 AM

No comments:

Post a Comment

Copyright © 2013 Car modification - Review Car Picture Hot Wallpaper